Interior drain tile, sump basins, and vapor barrier wall systems installed by technicians who've done this hundreds of times in Wayne, MI basements.
We've seen enough Wayne, MI basements to know that a wet spot in one corner rarely tells the whole story. Before we recommend drain tile or a sump upgrade, we trace the water back to where it's actually entering, not just where you noticed it.
We're bonded and insured for both residential and light commercial basement work across Wayne, MI.
Most inspection requests get a same-day or next-day appointment, not a two-week wait.
You get one written number before drilling starts, covering drain tile, sump basin, and discharge line.
We use pin-type moisture meters and a flashlight-and-crowbar inspection to trace water back to its real entry point.
Every Wayne, MI Basement Waterproofing job starts with an inspection, not a generic package — here's what that typically includes.
The core fix for most Wayne, MI basements: a perimeter drain cut into the slab edge, tied to a sump basin, that intercepts water before it reaches the floor.
Every drain tile system needs a properly sized sump pump — we calculate basin size and pump horsepower from your square footage and local water table depth.
Vertical wall cracks get epoxy or polyurethane injection depending on whether they're still actively weeping.
A dimpled plastic membrane behind any finished basement wall channels residual moisture down to the drain tile instead of trapping it behind drywall.
Window wells that hold water after a storm are a direct pressure point against the glass and frame — we add gravel beds and drain lines tied into the main system.
You describe what you're seeing — a wet spot, a musty smell, standing water — and we get a rough read on urgency before dispatching anyone.
A technician walks the basement with a moisture meter, checking walls, floor, and cove joints to trace the water back to its actual source.
You'll see drain tile footage, sump specs, and labor broken out separately, not one vague lump-sum number.
Most residential basement jobs finish in one to three days, and we test the sump pump under load before we leave.
"Our finished basement started smelling musty and we finally found a wet spot behind the drywall. They cut open the cove joint, ran drain tile, and it's been dry for over a year."
— Wayne Homeowner
"Sump basin was undersized from the last owner's DIY job. They resized it and we haven't had a drop since."
— Wayne Customer
"Appreciated that the estimate matched the final invoice exactly — no surprise add-ons once the floor was already open."
— Wayne Homeowner
"Basement had been damp for years. Drain tile and a new sump system fixed it in three days."
— Wayne Customer
Cost depends on linear footage, sump basin size, and whether cove joint sealing is included — we won't give a number without an in-person inspection.
We keep the cut as narrow as possible and clean up debris before leaving the site.
Most residential interior drain tile and sump installations finish in one to three days depending on basement size.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
Coverage depends on your policy and the cause of the water intrusion — we can document conditions for a claim, but approval is up to your insurer.
Yes, every interior drain tile and sump installation comes with a written warranty, explained in full before you approve the quote.
If your Wayne address falls just outside our standard coverage zone, call anyway — we often still make the trip for basement emergencies.
Zip codes we serve in Wayne, MI: 48184
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
